SH-5210-HD Hydraulic Plate Shear
 |
Lease to own for $ per month! |  |
Shearing Position Indicator Light
| Specifications | |
| Max. Shear Length |
51.96”
|
| Max Material Thickness - Mid Steel | .137” |
| Max Material Thickness - Stainless Steel | .086” |
| Strokes / Minute | 35 - 47 s.p.m. |
| Hold Down Qty. | 8 |
| Hold Down Pressure | 2.8 ton |
| Front Gauge Length | 39.37” |
| Back Gauge Length | 23.62” (manual) |
| Blade Rake Angle | ½ - 2 deg (hydraulic) |
| Motor | 7.5 hp |
| Power Requirement | 220 volt / 3 phase / 60 hertz |
| Oil Capacity | 25 gal |
| Shipping Dimensions (L/W/H) |
90.55” / 47.24” / 62.99”
|
| Shipping Weight | 3960 lbs |
The SH-5210HD hydraulic sheet metal cutting shear is a heavy duty machine built for years of production. This machine has thick steel plate frame that is electro welded and uses industrial grade hydraulics.
This hydraulic sheet metal cutting shear has a very rigid carriage that rides against hardened carriage ways. Heavy duty bearings are used to reduce friction and wear. The front side of the machine has a heavy duty load table and side gauges. At the rear of the machine is a manual back gauge.
The centralized control panel offers the selection of jog, single or continuous cutting modes. There is also a dial for adjusting the rake that eliminates curl and twist in cutting. The upper blade is two sided while the lower blade is four sided. The blades can be surface ground when dulling occurs for further blade life.
Like all Baileigh Industrial hydraulic sheet metal cutting shears, this one is built for decades of operation.